20
The diagram below is intended to show you how to fit the individual system components.
For detailed information about the individual steps, please refer to the operating instruc-
tions for the system components.
Fitting the sys-
tem components
(overview)
Commissioning a TSt 3500/5000 power source
General Commissioning a TSt 3500/5000 power source is described by reference to a manual
water-cooled MIG/MAG application.
Fitting the system components
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. The following activities must only be carried out by trained and
qualified personnel. Pay particular attention to the „Safety rules“ section.
To Next Page
Loading...
