22
Side of wirefeeder
No. Function
(1) Wirespool holder with brake
for holding standard wirespools with a max. diameter of 300 mm (11.81 in.) and a
max. weight of up to 19 kg (41.89 lbs.)
(2) Program selector
(option)
(3) 4-roller drive
(4) Optional "Wire threading / Gas-test" button
Push button downwards:
For threading the wire electrode into the torch hosepack with no accompanying
flow of gas or current. While the button is being held down, the wirefeeder runs at
feeder inching speed.
Push button upwards:
For setting the required gas flow rate on the pressure regulator.
- Tap button once: shielding gas flows out
- Tap button again: shielding gas flow stops
If the "Gas-test" button is not tapped again, the shielding gas flow will stop after 30
s.
To Next Page
Loading...
