32
3
Design of the
brake
WARNING!
Danger from incorrect installation.
This can result in severe personal injury
and damage to property.
► Do not dismantle the brake.
► Maintenance and servicing of brakes is
to be carried out by trained, qualified
personnel only.
The brake is only available as a complete
unit.
This illustration is for information purposes
only.
Prerequisites for
start-up
WARNING!
Operating the equipment incorrectly can cause serious injury and damage.
Do not use the functions described until you have thoroughly read and understood the fol-
lowing documents:
► these operating instructions
► all the operating instructions for the system components, especially the safety rules
When commissioning the wirefeeder, the following requirements must be met:
- Wirefeeder connected to the power source using the interconnecting hosepack
- Welding torch connected to the wirefeeder
- Feed rollers inserted into the wirefeeder
- Wirespool or basket-type spool and adapter inserted in the wirefeeder
- Wire electrode fed in
- Feed roller contact pressure is set
- Brake adjusted
- All covers closed, all side panels in place, all protection devices intact and in their
proper place
The wirefeeder is started by pressing the torch trigger (for manual applications) or by
means of a welding start-up signal (for automatic applications).
3
To Next Page
Loading...
