36
Synergic B con-
trol panel
(1) "Material" button
For selecting the filler metal to be
used. The SP parameter is reser-
ved for additional filler metals.
When a material is selected, the
LED behind the relevant filler metal
lights up.
(2) "Wire diameter" button
For selecting the wire diameter to be used. The SP parameter is reserved for ad-
ditional wire diameters.
When a wire diameter is selected, the LED behind the relevant wire diameter lights
up.
(3) "Shielding gas" button
For selecting the shielding gas to be used. The SP parameter is reserved for addi-
tional shielding gases.
When a shielding gas is selected, the LED behind the relevant shielding gas lights
up.
Keylock A keylock can be selected to prevent the settings from being inadvertently changed on the
control panel. As long as the keylock is active
- no settings can be made on the control panel
- only parameter settings can be retrieved
- any assigned "Save" button can be retrieved provided that an assigned "Save" button
was selected when the keylock was enabled
Activate/deactivate the keylock as follows:
Press and hold the "Mode" button
Press the "Parameter selection" button
(right)
Release the "Mode" and "Parameter
selection" buttons
Keylock activated:
The message "CLO | SEd" appears on the displays.
Keylock deactivated:
The message "OP | En" appears on the displays.
To Next Page
Loading...
