Fronius VR 5000 Remote - Start-up Procedures; Placing Wirefeeder on Power Source; Fitting Hosepack Strain-Relief

24
Start-up
General Commissioning a power source is described by reference to a manual water-cooled MIG/
MAG application.
Placing the wire-
feeder on the
power source
CAUTION!
Risk of injury and material damage from falling wirefeeder.
► Make sure that the wirefeeeder is located securely on the swivel pin and that the de-
vices, upright consoles and trolleys are stable.
1
Fitting the inter-
connecting hose-
pack strain-relief
device
1
Fitting the strain-relief device to the trolley
2
Fitting the strain-relief device to the wirefeeder
IMPORTANT! To prevent wear and tear, leave some slack when connecting the cables. A
strain-relief device is not provided in the case of 1.2 m (3 ft. 11.24 in.) interconnecting hose-
packs.
1
1
1
2
3
4
1
2
1
3
4
2