Fronius VR 5000 Remote - Accessing the Setup Menu

45
EN
Accessing the
Setup menu
Accessing the Setup menu
Use the "Process" button to select the
required welding process
Press and hold the "Mode" button
Press the "Process" button
Release the "Mode" and "Process"
buttons
The control panel is now in the Setup menu of the chosen welding process - the last Setup
parameter that was selected is displayed.
Accessing the Level 2 Setup menu
Use the "Mode" and "Process" buttons
or the left-hand adjusting dial to select
the "2nd" Setup parameter
Press and hold the "Mode" button
Press the "Process" button
Release the "Mode" and "Process"
buttons
Changing welding parameters
Use the "Mode" and "Process" buttons
or the left-hand adjusting dial to select
the required Setup parameter
Use the "Parameter selection" buttons
or the right-hand adjusting dial to
change the value of the Setup parame-
ter
1
2
3
4
5
6
7
8
9
10