Fronius VR 5000 Remote - Setting the Contact Pressure; Adjusting the Brake

31
EN
Setting the con-
tact pressure
CAUTION!
Risk from excessive contact pressure.
This can result in severe damage to property and poor weld properties.
► Set the contact pressure in such a way that the wire electrode is not deformed, but is
nevertheless transported properly.
1
Contact pressure standard values for U-
groove rollers:
Steel: 4 - 5
CrNi: 4 - 5
Tubular cored electrodes 2 - 3
Adjusting the
brake
NOTE!
After releasing the "Wire threading" button, the wirespool should stop unreeling.
► If it continues unreeling, readjust the brake.
1 2
1
1
4
6
7
1
2
STOP
3
5
1
2
1
2