Fronius VR 5000 Remote - Setup Parameters; Service Parameters

46
Exiting the Level 2 Setup menu
Press and hold the "Mode" button
Press the "Process" button
Release the "Mode" and "Process"
buttons
Exiting the Setup menu
Press and hold the "Mode" button
Press the "Process" button
Release the "Mode" and "Process"
buttons
Setup parameters See TransSteel 4000 / 5000 Pulse Operating Instructions (42,0426,0353,XX)
Service parame-
ters
Various service parameters can be retrieved by pressing the "Parameter selection" buttons
at the same time.
Opening the display
Press and hold the "Parameter selecti-
on" button (left)
Press the "Parameter selection" button
(right)
Release the "Parameter selection" but-
tons
The first parameter ("Firmware version") is displayed, e.g. "1.00 | 4.21"
Selecting parameters
Use the "Mode" and "Process" buttons
or the left-hand adjusting dial to select
the required Setup parameter
11
12
13
14
15
16
1
2
3
1