35
EN
(4) Adjusting dial (left)
For changing the sheet thickness, welding current and wire speed welding param-
eters
For selecting welding parameters in the Setup menu
(5) "Process" button
***)
For selecting the welding process
MANUAL - MIG/MAG standard manual welding
SYNERGIC - MIG/MAG standard synergic welding
STICK - Manual metal arc (MMA) welding
(6) "Mode" button
For selecting the operating mode
2 T - 2-step mode
4 T - 4-step mode
S 4 T - Special 4-step mode
(7) "Save" buttons (Easy Job)
For saving up to 5 operating points
(8) "Intermediate arc" indicator
A spatter-prone intermediate arc occurs between the dip transfer arc and the spray
arc. The intermediate arc indicator lights up to draw attention to this critical area.
(9) HOLD indicator
At the end of each welding operation, the actual values for welding current and
welding voltage are stored - the "HOLD" indicator lights up.
(10) SF - spot / stitch welding indicator
Lights up if a value has been entered for the spot / stitch welding time Setup pa-
rameter (SPt) (spot or stitch welding operating mode is enabled)
*) If one of these parameters is selected in the MIG/MAG standard synergic welding
process, then the synergic function ensures that all other parameters, including the
welding voltage parameter, are adjusted automatically.
**) The Real Energy Input display must be activated in level 2 of the Setup menu –
EnE parameter.
The value continuously rises during welding in line with the permanently increasing
energy yield. The final value at the end of welding remains stored until welding
starts again or the power source is switched back on - the HOLD indicator lights up.
***) In conjunction with the VRD option, the currently selected welding process indica-
tor is simultaneously an additional indicator:
- The indicator is permanently lit:
the Voltage Reduction Device (VRD) is active and is limiting the output voltage to
less than 35 V.
- The indicator starts to flash as soon as a welding action starts in which the output
voltage can exceed 35 V.
To Next Page
Loading...
