Fronius VR 5000 Remote - Synergic A Control Panel Functions

34
No. Function
(1) "Parameter selection" button (right)
a) for selecting the following welding parameters
Arc length correction
For correcting the arc length
Welding voltage in V
*)
Before the start of welding, the device automatically displays a standard value
based on the programmed parameters. The actual value is displayed during weld-
ing.
Arc-force dynamic
For influencing the short-circuiting dynamic at the moment of droplet transfer
- ... harder, more stable arc
0 ... neutral arc
+ ... soft, low-spatter arc
Real Energy Input
For displaying the energy applied during the welding operation.
**)
b) for changing parameters in the Setup menu
(2) "Parameter selection" button (left)
a) for selecting the following welding parameters
Sheet thickness
Sheet thickness in mm or in.
Welding current
*)
Welding current in A
Before the start of welding, the device automatically displays a standard value
based on the programmed parameters. The actual value is displayed during weld-
ing.
Wire speed
*)
Wire speed in m/min or ipm.
b) for changing parameters in the Setup menu
(3) Adjusting dial (right)
For changing the arc length correction, welding voltage and arc-force dynamic
welding parameters
For changing welding parameters in the Setup menu