42
(7) "Process" button
***)
For selecting the welding process
MIG/MAG standard manual welding
MIG/MAG standard synergic welding / MIG/MAG pulse synergic welding
MMA welding
(8) "Mode" button
For selecting the operating mode
2-step mode
4-step mode
Spot welding / Stitch welding / Special 4-step mode
(9) "Save" buttons (Easy Job)
For saving up to 5 operating points
(10) Adjusting dial (left)
For changing the sheet thickness, welding current and wire speed welding param-
eters
For selecting welding parameters in the Setup menu
(11) "Parameter selection" button (left)
a) for selecting the following welding parameters
Sheet thickness
Sheet thickness in mm or in.
Welding current
*)
Welding current in A
Before the start of welding, the device automatically displays a standard value
based on the programmed parameters. The actual value is displayed during weld-
ing.
Wire speed
*)
Wire speed in m/min or ipm.
b) for changing parameters in the Setup menu
(12) SF - spot / stitch / SynchroPulse welding indicator
- Lights up if a value has been entered for the spot/stitch welding time Setup pa-
rameter (SPt) when spot or stitch welding mode is enabled.
- Lights up if a value has been entered for the frequency (F) Setup parameter when
the MIG/MAG synergic process is enabled.
To Next Page
Loading...
