NOTE!
The electric vehicle is not listed - select standard charging behaviour.
If the electric vehicle to be charged is not listed, no specific charging behaviour is known.
All defaults can be customised.
▶
Select the standard charging behaviour.
- Choose car: The optimised standard settings of different car models can be activ-
ated under "Select car".
- Minimum current: Some cars will not resume charging after an interruption. To pre-
vent an interruption, the minimum charging current can be set.
- Choose phase switch:
- Automatic: A power level can be set, from which 3‑phase charging takes place.
If "0" is set, the Wattpilot immediately starts 3‑phase charging.
- Only 1‑phase: There is 1 phase available for charging.
- Only 3‑phase: There are 3 phases available for charging.
- 3‑phase power level: Set a power level that must be reached by the photovoltaic
system before the Wattpilot switches from 1‑phase to 3‑phase charging. If the avail-
able power is greater than the set value, the Wattpilot immediately activates 3‑phase
charging. Automatic switching can be deactivated in the car settings.
- Forced charging interval: In the case of cost-optimised charging, the Wattpilot
interrupts the charging process if the electricity price is too high. Some cars will not
tolerate interruptions and will not continue charging after prolonged interruptions to
the charging process. In this case, the charging process must be started regularly
for a short time.
- Simulate unplugging: Some cars need to be disconnected for a while if there has
been an interruption during cost-optimised charging. This function simulates a dis-
connection before charging continues.
Charging timer The "Charging timer" setting limits charging to specific times. A start and end time must
be specified for this. Several time windows can be set. The following can be set:
- The time (start and end time) and
- The days of the week.
NOTE!
Verhalten bei aktiviertem Eco Mode or Next Trip Mode:
If charging is not allowed by the charging timer for a certain period of time, Eco Mode
and Next Trip Mode are also blocked for this period.
If the charging timer does allow charging in a certain period of time but the settings for
Eco Mode or Next Trip Mode are not met, charging will not occur.
Brightness Set LED brightness values. By activating "Switch off LEDs after 10 s in standby", the
LEDs on the device are switched off after 10 seconds in standby.
LED colours Customise LED colours.
Time zone Set the time zone. Activating "Automatic summer time changeover" automatically sets
the summer and winter time.
45
EN
To Next Page
Loading...
Need help?
General
