Settings
Current level Five different current levels can be set. The current levels are selected from Level 1
(gentle) to Level 5 (rapid) by pressing the pushbutton on the Wattpilot. Adjust the desired
levels by clicking in the respective field.
Absolute maximum
This setting is used to adjust the maximum charging current of the Wattpilot. Higher char-
ging currents can no longer be selected.
NOTE!
The infrastructure is not known!
If charging in an unknown infrastructure, always charge with the lowest charging current
(e.g. 6 A or 10 A).
▶
Charge with the lowest charging current.
NOTE!
Increase the service life of the battery.
A slow charge with a low amperage is gentler on the battery of the electric vehicle. This
can extend the service life of the battery.
▶
Charge with a low charging current.
Next Trip Mode Charging is carried out as cheaply as possible using surplus PV current (see PV sur-
plus) and a flexible electricity tariff (see Flexible electricity tariff).
1
Under "Settings", click on the "Next Trip Mode" button.
2
Enter the minimum range in kilometres (km).
- 100 km corresponds to 18 kWh.
3
Enter the time by which charging must be complete.
Activating "Next Trip Mode"
- Directly on the Wattpilot by pressing the pushbutton (see Pushbutton functions).
- In the app, under "Charging", click on the "Mode" button and activate "Next Trip
Mode".
Activating "Remain in Eco Mode"
After reaching the set range, the Wattpilot switches from Next Trip Mode to Eco Mode.
Charging continues with the Eco Mode settings.
Cost optimisation Under "Cost optimisation", the consideration of the electricity tariff (see Flexible electri-
city tariff) and the use of PV surplus (see PV surplus) can be activated. The settings
listed below can also be customised.
Use Lumina Strom / aWattar
Activation or deactivation of flexible electricity tariffs.
Eco Mode price limit
When a flexible electricity tariff is activated in Eco Mode, charging does not start until the
43
EN
To Next Page
Loading...
Need help?
General
