1-6
Left Display Right Display Action
VAT SETUP
Enter
code
Enter 1656.
SYSTEM
Press to scroll to FILTER.
FILTER
Press .
Cooks
till
Filter
0
(This is the total number of cooks that occur before a filter prompt. The default is 0.)
Enter the number of cooks before a filter prompt is desired. Press .
FILTER
LOCKOUT
NONE
Press to scroll to choice NONE, MAX or MIN and press . (Default is NONE)
NONE=Disabled, MIN=a filtration must occur at each prompt. No bypasses are
allowed. MAX= allows a filter to be bypassed once. At the next filter prompt the vat
must be filtered. NOTE: This affects Filter and Clean and Filter functions.
EOD
FILTER
TIMER
DISABLED
Press to scroll to choice enable or disable and press . (Default is DISABLED)
EOD
filter
time
23:59
Use numbered keys to program end of day filter alert time. Enter time in 24 hour
format. After this time, the controller prompts for filter when user presses the power
button to go to OFF. Enter 23:59 if no end of day filter prompt is desired. Press .
FLUSHING
TIMER
5
Use numbered keys to change default setting for the flushing timer. Enter the time in
minutes. Default is five minutes. Press .
CLEAN HOT
Press to scroll to choice HOT (Boil Out) or COLD (Cold Soak) and press .
(Default is HOT (Boil Out)
CLEAN
timer
30
Use numbered keys to change default setting for the hot (Boil Out) or cold clean (Cold
Soak) timer. Enter the time in minutes. Default is 30 minutes. Press .
POLISH
LOCKOUT
DISABLED
Press to scroll to choice enable or disable and press . (Default is DISABLED)
If enabled, allows a polish to be bypassed once. On the next polish prompt the vat
must be filtered.
1 polish
TIMER
DISABLED
Press to scroll to choice enable or disable and press . (Default is DISABLED).
Press .
1 polish
prompt
time
23:59
Use numbered keys to enter polish prompt time. (This is the time the polish prompt
will occur each day.) 23:59 is disabled. Enter time in 24 hour format. Press .
1 polish
DELAY
timeR
00:30
Use numbered keys to change time (use 10 for 0). (This is the amount of time which an
operator can delay the start of a polish.) Press . After the delay the operator must
polish.
1 polish
duration
15
Use numbered keys to change. (This is the duration, in minutes for a polish.) Default is
15 minutes. Press .
ENABLE
FILTERS
PERCENT
Press . Press to scroll to choice YES or NO and press . Default is NO. Press
. This is the total percentage of products cooked and cooks remaining to filter cycle.
1 polish
start
TEMPR
(300F)
(149°C)
Use numbered buttons to change temperature. (This is the minimum temperature
required for a polish to begin.) Default is 300F (149C). Press .
CLEAN
AND
FILTER
TIMER
DISABLED
Press to scroll to choice enable or disable and press . (Default is DISABLED).
Press . This is a prompt to perform a clean and filter.
CLEAN
AND
FILTER
prompt
time
14:00
Use numbered keys to enter clean and filter prompt time. (This is the time the clean
and filter prompt will occur each day if enabled.) 23:59 is disabled. Enter time in 24
hour format. Press . (Default is 14:00).
To Next Page
Loading...
