1-22
Left Display Right Display Action
BOIL OUT DONE
or COLD CLEAN
DONE
CONFIRM
Press arrow under CONFIRM to cancel the alarm.
REMOVE FILTER
PAN
Open the door and pull filter pan out of the cabinet.
INSERT
DISPOSAL PAN
CONFIRM
Insert disposal pan large enough to contain FOUR gallons (15
liters) or more for FQE30 or FQG30 fryers, or EIGHT gallons
(30 liters) or more for 1814E or 1814G fryers under the drain and
press arrow under CONFIRM.
OPEN DRAIN
valve
Press button with blinking LED.
DRAINING
None required.
IS SOLUTION
REMOVED?
CONFIRM
Press arrow under CONFIRM.
RINSE
COMPLETE?
CONFIRM
Rinse the vat with water and press arrow under CONFIRM.
VAT AND PAN
DRY?
CONFIRM
Ensure the vat and filter pan are completely dry and press arrow
under CONFIRM.
REMOVE
DISPOSAL PAN
CONFIRM
Remove the disposal pan and press arrow under CONFIRM.
INSERT FILTER
PAN
Insert Filter pan
FILL VAT FROM
BULK?
Yes / No
Press (YES) arrow to fill vat or (NO) arrow to go to OFF.
PRESS AND HOLD
YES TO FILL
Yes
Press and hold (YES) to fill.
FILLING
Displayed while filling vat.
CONTINUE
FILLING?
Yes / No
Press (NO) arrow when full, otherwise press (YES) arrow to
continue filling.
OFF OFF
1.10 Polishing
The FilterQuick™ controller displays a series of prompts when a polish filter cycle is under way. To initiate a polish, press
and hold the arrows simultaneously when the controller displays READY. The steps are detailed below. A “WAIT
TO POLISH” message may appear until the signal is received that the vat is ready for polish cycle to begin.
Left Display Right Display Action
LEFT (Split vats
only)
RIGHT (Split vats only)
Press appropriate arrow under side to filter.
POLISH NOW? Yes / NO
Press the (YES) arrow to continue. Press (NO) arrow to bypass a
polish and return to previous state; POL DLYD will be displayed.
Pressing the arrows simultaneously when the controller
displays POL DLYD will prompt a polish. If the controller is turned
OFF during the polish now prompt, a polish prompt is displayed. If
no is selected, the polish prompt will return once the controller is
soft powered on again. If the controller is turned OFF when POL
DLYD is displayed, the polish prompt will return once the controller
is soft powered on again. If polish lockout is enabled, a polish has to
be completed on the next prompt.
SKIM VAT or
OIL TOO LOW.
CONFIRM or OIL
TOO LOW display
Skim the vat and press arrow under CONFIRM. If the oil level is
too low, the controller displays “OIL TO LOW”. Fill the vat and
To Next Page
Loading...
