Frymaster FilterQuick Version 2 - OQS Filter with OQS (Set to Number)

3-4
Left Display Right Display Action
FILLING
None required.
TPM
X–
/ – X alternating
None required. The pump stops and the OQS sensor calculates
the TPM value of the oil.
FILLING
None required. The pump continues filling the frypot.
IS VAT FULL? YES / NO
Press (YES) if the vat is full.
If TPM reading is below OQS SETUP – DISCARD NOW and
DISCARD SOON limits, proceed to OIL IS GOOD step.
If TPM reading is below OQS SETUP – DISCARD NOW but
above DISCARD SOON limits, proceed to DISCARD SOON
step.
If TPM reading is above OQS SETUP – DISCARD limits,
proceed to DISCARD NOW step.
OIL IS GOOD
None required. Return to normal operation and advance to OFF
(below).
DISCARD SOON CONFIRM
Displayed if TPM reading is below OQS SETUP – DISCARD
NOW, but the TPM value has reached the DISCARD SOON
limits, press arrow under CONFIRM and advance to OFF
(below).
DISCARD NOW? YES / NO
Displayed if the value in OQS SETUP – DISCARD NOW is
exceeded. Press (YES) arrow to continue to DISCARD NOW
function. Press (NO) arrow to return to normal operation and
advance to OFF (below).
POLISHING
5:00 TIMER
None required. The oil flows from the filter pan to the frypot and
back to the filter pan for 5 minutes.
CLOSE DRAIN CONFIRM
Press arrow under CONFIRM.
FILLING
None required.
IS VAT FULL? YES / NO
Press (YES) if the vat is full. Press (NO) to continue filling.
OFF OFF
3.3.3 OQS Filter with OQS (Set to Number)
Left Display Right Display Action
FILTER
Press and hold FILTER button until FILTER is displayed.
LEFT (Split vats only)
RIGHT (Split vats
only)
Press appropriate arrow to select side.
OQS
Press the  button.
OQS FILTER
NOW?
YES / NO
Press (YES) arrow to continue. Press (NO) arrow to bypass
filtration and return to previous state.
SKIM VAT or OIL
TOO LOW.
CONFIRM or OIL
TOO LOW display
Skim the vat and press arrow under CONFIRM. If the oil level is
too low, the controller displays “OIL TO LOW”. Fill the vat and
press either arrow under CONFIRM.
START
FILTRATION
Press button with blinking LED.
DRAINING
None required. If the drain becomes clogged, use the Fryer’s Friend
to clear the blockage.
FLUSHING
None required.
FILLING
None required.
TPM
X–
/ – X alternating
None required. The pump stops and the OQS sensor calculates the
TPM value of the oil.
FILLING
None required. The pump continues filling the frypot.
IS VAT FULL? YES / NO
Press (YES) if the vat is full. Press (NO) to continue filling.
WAIT FOR FILTER
TPM ###
Displays the TPM value. If TPM reading is within limits, skip to ---
-------- or LOW TEMP step below.
DISCARD NOW? YES / NO
Displayed if the value in OQS SETUP – DISCARD NOW is