Frymaster FilterQuick Version 2 - Clean and Filter with OQS (Set to Text)

3-3
Left Display Right Display Action
POLISHING
5:00 TIMER
None required. The oil flows from the filter pan to the frypot and
b
ack to the filter pan for 5 minutes.
CLOSE DRAIN CONFIRM
Press arrow under CONFIRM.
FILLING
None required.
TPM
X–
/ – X alternating
None required. The pump stops and the OQS sensor calculates
the TPM value of the oil.
FILLING
None required. The pump continues filling the frypot.
IS VAT FULL? YES / NO
Press (YES) if the vat is full. Press (NO) to continue filling.
WAIT FOR FILTER
TPM ###
Displays the TPM value. If TPM reading is within limits, skip to
OFF step below, otherwise proceed to next step.
DISCARD NOW? YES / NO
Displayed if the value in OQS SETUP – DISCARD NOW is
attained. Press (YES) arrow to continue to DISCARD function.
Press (NO) arrow to return to normal operation and skip to OFF
(below).
POLISHING
5:00 TIMER
None required. The oil flows from the filter pan to the frypot and
b
ack to the filter pan for 5 minutes.
CLOSE DRAIN CONFIRM
Press arrow under CONFIRM.
FILLING
None required.
IS VAT FULL? YES / NO
Press (YES) if the vat is full. Press (NO) to continue filling.
OFF OFF
3.3.2 Clean and Filter with OQS (Set to Text)
Left Display Right Display Action
Follow steps to Enterin
g
Filter Menu Mode above in section 3.3.
LEFT (Split vats only)
RIGHT (Split vats
onl
y
)
Press appropriate arrow to select side.
CLEAN AND
FILTER
Press .
CLEAN NOW? YES / NO
Press (YES) arrow to continue. Press (NO) arrow to cancel and
return to previous state. See section 1.9.2 for additional
information.
SKIM VAT
Skim the vat.
START
FILTRATION
Press button with blinking LED.
DRAINING
None required. If the drain becomes clogged, use the Fryer’s
Friend to clear the blocka
g
e
CLEAN OIL
SENSOR
CONFIRM
(Gas Only) Clean oil sensor with a no scratch pad and press
arrow under CONFIRM.
FLUSHING
Use brush and hot oil to wash down crumbs and residue from the
frypot walls and foam deck. Use no scratch pad to remove
residue. Frypot surface will be hot, use thermal gloves and
extreme care.
SCRUB VAT
COMPLETE?
CONFIRM
Press arrow under CONFIRM. NOTE: This step may be
shown if CHOICE is selected in setup.
OQS FILTER
YES / NO
Press (YES) arrow to continue. Press (NO) arrow to advance to
the POLISHING step below. (Follow the arrows to the left.)
N
OTE: This step ma
y
be shown if CHOICE is selected in setup.
POLISHING 5:00 TIMER
None required. The oil flows from the filter pan to the frypot and
b
ack to the filter pan for 5 minutes.
CLOSE DRAIN CONFIRM
Press arrow under CONFIRM.