1-7
Left Display Right Display Action
CLEAN
AND
FILTER
DELAY
timeR
01:00
Use numbered keys to change time (use 10 for 0). (This is the amount of time which an
operator can delay the start of a clean and filter delay timer.) If the delay time = 0, no
delay is allowed. Press . After the delay the operator must perform a clean and filter.
CLEAN
AND
FILTER
start
TEMPR
(300F)
(149°C)
Use numbered buttons to change temperature. (This is the minimum temperature
required for a clean and filter to begin.) (Default is 300F (149C)). Press .
CHANGE
FILTER
PAD
INTERVAL
H
25
Use numbered keys to adjust CHANGE FILTER PAPER prompt. (This is the amount
of time in hours after the filter paper has been changed before the next prompt will
occur.) (The default is set to 25 hours.) If the value = 0, the CHANGE FILTER
PAPER prompt is disabled. Press .
OQS DISABLED
If installed, see section 3.1 in Chapter 3.
Exit Exit
Press the Exit/Scan button once to return the controller to OFF.
E-LOG
OFF OFF
Press until the controller scrolls INFO MODE, changing to MAIN and then
PRODUCT SETUP.
PRODUCT
SETUP
Press to scroll to Vat Setup. Press .
VAT SETUP
Enter
code
Enter 1656.
SYSTEM
Press to scroll to E-LOG.
E-LOG
Press . (This is a log of the ten most recent error codes.)
NOW Time/date
Press . (Current time and date)
A thru j Time/date
Errors listed A-J. Press to scroll through errors. Error codes are listed on page 2-4.
If no errors exist, pressing will display No errors. Press .
Exit Exit
Press the Exit/Scan button three times to return the controller to OFF.
CHANGE
PASSWORD
OFF OFF
Press until the controller scrolls INFO MODE, changing to MAIN and then
PRODUCT SETUP.
PRODUCT
SETUP
Press to scroll to Vat Setup. Press .
VAT SETUP
Enter
code
Enter 1656.
SYSTEM
Press to scroll to Change Password.
CHANGE
PASSWORD
Press .
Product
setup
1650
Use numbered keys to change code. Press .
Vat setup 1656
Use numbered keys to change code. Press .
Exit Exit
Press the Exit/Scan button three times to return the controller to OFF.
To Next Page
Loading...
