FSI DM160 - Fast Mode Processing Types

© 2023 Flanders Scientic, Inc.
29
Return to Table of Contents
Video Menu
Fast Mode
This selection allows you to set the type of Fast Mode processing that will be used when the Fast Mode function is enabled
via an assigned function button. This setting only applies to interlaced video signals. For progressive and PsF video signals
there is only 1 type of fast mode processing that will automatically be selected when Fast Mode is enabled so the setting
here does not apply in those scenarios.
The available Fast Modes are:
Standard Mode: Frame buffer is used allowing 1st eld to be captured then processed along with 2nd eld for display
on screen.
Black Insert: Inserts black eld for nearly instantaneous display of source. This mode may result in a slight drop in
overall image luminance.
Half LUM: Inserts a half light eld for nearly instantaneous display of source with less impact on overall luminance than
Black Insert. This mode looks very similar to a CRT owing to a CRTs average pixel decay (fall) time.
Field Copy: Line-doubler processing mode for nearly instantaneous display of source.
Flicker Free Mode (Only applies to DM250)
When turned ON this mode eliminates the low frame rate icker typical of OLED monitors with ultrafast pixel response times.
On is the default setting, we recommend keeping it activated. The DM250 allows this mode to be disabled if desired.
Part Display
Toggles whether just the center part (On) or entire source (Off) is shown in Sub Window Mode.