FSI DM160 - Color Management Menu Settings

© 2023 Flanders Scientic, Inc.
36
Return to Table of Contents
Color Management Menu
Main Menu Color Management
Function Color Space Rec 709
Real Time Scopes Gamma Select Gamma 2.4
Scopes & Audio Meters Color Temperature 6500K
Video Color Matching CIE 1931
Audio HDR Preview
Marker Mesopic Optimization Disable
Alarm Luminance Mode Standard Mode
OSD Luminance 100
GPI LUT Bypass None
Color Management Update LUT
System Red Gain 50
System Status Green Gain 50
Support Blue Gain 50
Red Bias 50
Green Bias 50
Blue Bias 50
Log Mode Off
ACES Proxy v1.0.0 Off
SDI Black Level Video
Video Clipping Off
Custom Gamma Off
SDI Hue Adjustment Off
GaiaColor AutoCal
Reset Factory Alignment
Color Space
DM series monitors are equipped with the FSI CFE3 Color Fidelity Engine and have the ability to work in several different
color spaces. Select from available options to instantly change the active color space. Please note that switching color
spaces may take several seconds.
Gamma Select
This setting allows you to specify the desired gamma response of the monitor in 0.2 step increments ranging from a gamma
response of 1.8 to 2.8 as well as 2.35 and 1.0. The default gamma setting is 2.4, but any selection may be chosen for instant
adjustment of the monitor’s gamma response.
Color Temperature
Use this setting to set the desired color temperature. You can instantly toggle between 3200K, 5000K, 5600K, DCI, 6500K,
and 9300K. 6500K is the default setting.
Color Matching (Alternate CMF Selection for OLED Monitors)
FSI’s OLED monitors are capable of operating with calibration based on the standard CIE 1931 Color Matching Function or
the Judd Modied CMF, which has largely become the preferred CMF for use with OLEDs. As the Judd Modied CMF is an
easy to apply known offset from CIE 1931 for any given display type you can easily toggle between these without having to
recalibrate the monitor. This also allows for calibration using software and equipment based on the more common CIE 1931
CMF with the ability to quickly and easily apply the Judd based offset after calibration is complete.
All FSI Monitors are precisely
calibrated before shipping with NIST
traceable color analyzers specically
setup to measure the model in
question. However, if you would
manually like to adjust the white
balance of the monitor you may
do so by using the RGB Gain and
Bias adjustment. Please DO NOT
use the Reset Factory Alignment
function unless asked to do so
by an authorized FSI service
representative.
Menus longer than the Main
Menu including Video, Color
Management, and the System
menu will not fully display.
These menus will scroll.
Use the Up and Down keys to
scroll up and down a menu.