700-Bubbler-Man Rev 12 13 Feb 2020
Page 22/51
2) If an SD card is inserted, the SDCARD window will indicate EJECT. Select EJECT. If no SD card
is inserted a dash will be displayed. Go to Step 4.
3) Open the Bubbler case and remove the SD card (if present). The SD card slot is found on
the board on the interior of the Bubbler case lid.
IMPORTANT! The Bubbler should be opened in a protected environment free from
moisture, dust and other airborne debris which may enter the enclosure
5) Insert the SD card with the Firmware update into the SD card slot.
6) Close the Bubbler (it is not necessary to secure the lid). and go to the Diagnostics sub-
menu and select UPDATE. It will display the firmware version.
It is good practice to compare the VERSION and UPDATE displays to ensure the update is
to a higher version.
7) Press the “Select/Accept” button to initiate the download. The process normally takes less
than one minute.
IMPORTANT! DO NOT power cycle the Bubbler while the update is in progress
6
.
The display will flash while the update is downloading. When the display stops flashing,
the download is complete and the Bubbler will reset.
8) Return to the SETUP menu, SDCARD and select EJECT (refer to Step 2)
9) Remove the update SD card and replace the factory diagnostic SD card (if it was present).
10) Close and secure the Bubbler case lid.
.
6
If the Bubbler is power cycled during the download process, it will revert to the previous firmware version and
the firmware update must be re-initiated
To Next Page
Loading...
