- 14 -
1-2.Register/change of the lower limit comparison value
1. Push key “ ８
ＬＯ
”.
Letters marked with mesh is flashed.
Display shows the channel of CH “0” which is now used.
In the case that channel is changed, push ten-key for the channel No.
If change is not necessary, move to “2” below. (Value in Channel “0” is changed)
2. Push key “. ＳＥＴ／ＣＨＧ”.
←This is the state of waiting for the input of uppermost rank f
igure for lower limit comparison value.
← This is the present lower limit comparison value.
Please Input renewed lower limit comparison value using ten-key from upper to lower rank figure. Figure that is flashing is the
part for input. When “100” is changed to “95”, input “0095” by using ten-key.
3. Push key “S ＳＥＴ／ＣＨＧ”.
This action terminates the operation.
When values for the other channels are changed, newly carry out from 1 to thereafter.
◎If “Reset” key is pushed prior to push “SET/CHG” key of 3, operation is cancelled.
If incorrect value of “Upper limit comparison value ‹ Lower limit comparison value” is set, it becomes
unable to input. The setting should always be made to “Upper limit comparison value › Lower limit
comparison value”.
To Next Page
Loading...
Need help?
General