We thank you for the purchase of our CP-2 Type Press Controller.
In order to demonstrate the performance of this product enough, please be sure to read this instruction
manual to the last in the use. Please keep this manual carefully so that it can be referred to, when it
becomes necessary and use this equipment for long time.
In the case that this equipment is transferred to some other party, it is necessary to attach this instruction manual together
with the equipment.
This equipment is produced for the use in Japan. In the case of use in the other countries, the user should observe the laws
and regulations for the safety in such countries.
In order to operate safely and correctly
Please be observed following matters
Following matters shall be securely observed.
Use this equipment as an instrument for stamping. If it is used for some other purpose without having consultation with us,
the function, and performance cannot be assured.
Power source of AC100V +/- 10% 50/60Hz should be used. Do not connect with other power source.
Use this equipment at ambient temperature between 0℃ to 50℃. (Humidity: 80% maximum; Dew formation is not
allowed) Avoid areas where the equipment is directly exposed to the sunlight or hot wind.
Do not modify, disassemble, or repair by yourself. Please consult with us if necessary. If any repair or modification is
carried out without our consent, we are not responsible for any failure or incident caused by such act.
In this instruction, following symbols are indicated for the warning and caution in order to prevent the injury of
operators or other personnel and also to prevent the damage of property/equipment.
Warning
It indicates the potential situation by the misuse that may result in death or serious injury.
Caution
It indicates the potential situation by the misuse that may cause slight or minor injury.
This also indicates alarm that property damage may occur when equipment is not used safely.
CP-2 display (place of decimal point) is that of 03 (30kN rated loads) Load Cell being used.
To Next Page
Loading...
Need help?
General