Fuji Electric Model: PXR4 - Parameter Setting Methods; 1 st Block Parameters

– 12 –
5 Setting methods of temperature and paramenters
Standby
AL2AL1C1 C2 AL3
SEL
PXR-4
SV
PV
Control output status
Alarm status
PV value
indication
SV value
indication
When the set value (SV) is displayed at the lower line, the SV lamp is lit.
AL2AL1C1 C2 AL3
SEL
PXR-4
SV
PV
Operation/Standby mode
SV value
indication
flickers.
SEL SEL
Operation
Parameter
display symbol
Parameter
Standby settings
Description of contents
Default
setting
Remarks
STbY
ProG
LACH
AT
TM-2
AL1
A1-L
A2-L
A2-H
LoC
TM-1 Timer 1 display
Timer 2 display
Alarm 1 low limit
set value
Alarm 1 set value
(appears only with alarm action type 16 to 31).
Setting range: Note 1
Alarm 1 high limit
set value
(appears only with alarm action type 1 to 10).
Setting range: Note 1
Alarm 2 set value
10
10
A1-H
AL2
10
10
0
Switches RUN or Standby of the control.
ON: Control standby (output: OFF, alarm: OFF)
OFF: Control RUN
OFF: stop, rUn: Start, HLd: status hold
0: Stop, 1: Standard AT start, 2: Low PV type AT start
OFF
Alarm latch cancel Releases alarm latch.
1: Alarm latch release
0
Ramp/soak control
OFF
Auto-tuning
Time displays remining time at the timer mode.
(appears only with alarm action type 1 to 10).
Setting range: Note 1
(appears only with alarm action type 16 to 31).
Setting range: Note 1
(appears only with alarm action type 16 to 31).
Setting range: Note 1
Alarm 2 high limit
set value
(appears only with alarm action type 16 to 31).
Setting range: Note 1
Alarm 2 low limit
set value
Setting of key lock status. Key lock
10
0
10
10 Table 3
(Page 4)
Table 3
(Page 4)
Table 3
(Page 4)
Table 3
(Page 4)
Table 3
(Page 4)
Table 3
(Page 4)
10
All parameters
Front key
0
1
2
3
4
5
Comm-
unication
SV
Front key Comm-
unication
Note 1) Setting range :0 to 100%FS (in case of absolute value alarm)
100 to 100%FS (in case of deviation alarm)
Note 2) Never set "TC" / "TC2" = 0
· Some parameters may not be displayed on the screen, depending upon the types.
1st block parameter
: Setting enable, : Setting disable
Press for about 1 sec. Press for about 2 sec.