Fuji Electric Model: PXR4 - Communication Function [Option]

– 22 –
1) Function
· Data can be written/read through the MODBUS
®
protocol.
2) Before using this function, please set related parameters as shown below.
3rd block parameter
Set the station No. at "STno"
(station No. setting paramter).
[Sample: station No. = 18]
Set the parity at "COM".
[Sample: Odd parity]
CoM
0
1
2
Odd
Even
No parity
PV
SV
PV
SV
Please do not change "PYP"
unless used with PYP,
Color Touch-Operation Unit.
PV
SV
6-6 Communication function [option]
3) Caution
· Station No. can be set in the range of 0 to 255. (No communication is allowed with 0).
· After changing the setting of parity at “COM”, please power off and re-start the controller.
· Baud rate is fixed to 9600 bps.