39
INZ-TN2ZRE-E
Auto calibration status contact output is closed during auto calibration (NO side), and is open in other
cases.
Whether the auto calibration is set at ON or OFF, an auto calibration is available by remote start
input.
When an auto calibration starts, the measurement screen appears automatically.
Any operation other than “Stop Auto Calibration” (see Item 6.4.2) is
not permitted during auto calibration. “Stop Auto Calibration” cannot be performed
with the key lock to ON. To cancel auto calibration forcedly, set the key lock to OFF
and then execute “Stop Auto Calibration”.
Turn on the power again after it is turned off (including the case of power failure) at
the time set as the next start time in auto calibration, and then repeat it in the set cycle.
Caution
•
•
•
Remote start input
Without input
With input (hold at least 1.5 sec.)
Start Time
Cycle
Flow Time
ON/OFF
SUN
1
Zero
Ch1 Span
Ch2 Span
Ch3 Span
Ch4 Span
Ch5 Span
EX. time
ON
12:00
day
350 sec
350 sec
350 sec
350 sec
300 sec
300 sec
300 sec
(An example of “Ch1: through Ch5: enable”, as given in Item 6.2.4 “Auto Calibration
Components/range”)
Flow time
: Auto calibration
Sunday
12:00
Cycle
Zero
calibration
350sec 350sec
ChI
Span
calibration
350sec
Ch2
Span
calibration
Ch3
Span
calibration
Ch4
Span
calibration
Monday
12:00
Tuesday
12:00
Example
In case where auto calibration is carried out at the above setting.
Ch5
Span
calibration
350sec
300sec 300sec
Replace-
ment time
300sec
Cycle : 1 to 99 hours or 1 to 40 days (initial value 7 days)
Flow time : 60 to 900 sec (initial value 300 sec)
Setting range
To Next Page
Loading...
