-4-
Reference Guide Optional Units
(4) Remove the screw for the guide in front and remove the
guide from the Paper Tray.
(5) Insert the protrusions under the guide into the Paper
Size holes.
(6) Insert the Paper Tray protrusions into the Paper Size
holes on top of the guide and tighten the screw.
(7) Pull the lever for the end guide up ( ), align with the
Paper Size while moving the lever along the groove ( ),
and lower the lever ( ).
The groove on the left side of the end guide 8.5” is
not used.
4.
Fan a stack of paper, face the print surface down, and
then load the paper with edges aligned according to the
direction of the arrow.
1
2
3
1
2
To Next Page
Loading...
