9 Media Print-Text
334
Media Print-Text
9
Inserting USB Memory Device
1 Insert the USB memory device into the USB memory slot on the control panel.
2 One of the following occurs.
z
The [USB Memory Device Detected] screen appears.
z
The [Store to USB] screen appears.
z
The [Media Print - Text] screen appears.
z
The screen display does not change.
Note • The behavior depends on the settings. Ask your system administrator for more information.
• If you insert the USB memory device during the Energy Saver mode, the machine does not
detect it. Exit the Energy Saver mode, and then insert the USB memory device again or
select the [Store to USB] on the [Services Home] screen. For information how to exit the
Energy Saver mode, refer to "Exiting the Energy Saver Mode" (P.54).
• The screen status will be one of the above even when a USB memory device in which only
encrypted data is stored is inserted or USB memory device in unsupported format is
inserted. In such case, a warning message appears during operation and the operation is
aborted.
• The screen status will be one of the above when a commercially available Memory Card
Reader is inserted into the USB memory slot of the machine. It is the same if no media is
inserted into the Memory Card Reader.
• If a commercially available Memory Card Reader is used and it is left inserted all the time,
the machine does not detect media even when they are inserted into the slot of the Memory
Card Reader.
• The screen display remains the same when the inserted USB memory device or Memory
Card is removed. Press the <Services Home> button or do anything else to change the
screen display before starting next operation.
When [USB Device Detected] Screen Appears
1 Select [Media Print - Text].
2 The [Media Print -Text] screen appears.
3 Select a feature on the [Store to USB] screen.
Important • Data stored in a USB memory device may be lost or damaged in the following cases. Make
sure to back up the data in the device before use.
• When ejecting the medium or switching the power off/on by methods other than described
in this guide.
• When receiving the effect of electrical noise or an electrical discharge
To Next Page
Loading...
Need help?
General
