Control Panel
57
Product Overview
2
21 USB memory slot Insert a USB 2.0 memory device here.
Note • This feature is not available for some models. An optional
component is required. For more information, contact our
Customer Support Center.
22 One touch panels
(Only available for
machines with the Fax
service)
Contains the one touch buttons.
Turn over the panels to display buttons 1 - 54.
There are two ways in which address numbers and stored programs are
assigned to the one touch buttons. Select either of the following:
z
[Type 1]
The buttons 1 to 52 are used for address numbers and they
correspond to the registered address numbers 0001 to 0052, while the
buttons 53 and 54 are used for stored programs and they correspond
to the registered stored programs 1 and 2.
z
[Type 2]
The buttons 1 to 45 are used for address numbers and they
correspond to the registered address numbers 0001 to 0045, while the
buttons 46 to 54 are used for stored programs and they correspond to
the registered stored programs 1 to 9.
Note • By default, [Type 1] is selected.
• This feature is not available for some models. An optional
component is required. For more information, contact our
Customer Support Center.
For information on how to change the settings registered to the one touch
buttons, refer to "5 Tools" > "Common Service Settings" > "Screen/Button
Settings" in the Administrator Guide.
23 One touch buttons
(Only available for
machines with the Fax
service)
Allows you to specify a recipient by simply pressing one button. You can
use the buttons for fax and Internet fax jobs.
There are two ways in which address numbers and stored programs are
assigned to the one touch buttons. Select either of the following:
z
[Type 1]
The buttons 1 to 52 are used for address numbers and they
correspond to the registered address numbers 0001 to 0052, while the
buttons 53 and 54 are used for stored programs and they correspond
to the registered stored programs 1 and 2.
z
[Type 2]
The buttons 1 to 45 are used for address numbers and they
correspond to the registered address numbers 0001 to 0045, while the
buttons 46 to 54 are used for stored programs and they correspond to
the registered stored programs 1 to 9.
Note • By default, [Type 1] is selected.
• This feature is not available for some models. An optional
component is required. For more information, contact our
Customer Support Center.
For information on how to change the settings registered to the one touch
buttons, refer to "5 Tools" > "Common Service Settings" > "Screen/Button
Settings" in the Administrator Guide.
24 Paper clip tray Used for placing paper clips and staples.
No. Component Function
To Next Page
Loading...
Need help?
General
