Using CentreWare Internet Services
39
Environment Settings
2
- Automatically Configured Address 1:
The IPv6 address set automatically is displayed.
- Link-Local Address:
The link-local address set automatically is displayed.
- Gateway Address:
You can enter the gateway address when the [Enable Manual Address] checkbox
is checked.
- Automatically Configured Gateway Address:
The gateway address set automatically is displayed.
SNMP Configuration (Connectivity > Protocol)
You can set the SNMP protocol.
General
z
SNMP Port Status
You can check [Enabled] to use SNMP. (Default: On)
z
Edit SNMP v1/v2c Properties button
You can make advanced SNMP v1/v2c settings by pressing this button.
- Community Name (Read Only):
You can enter the community name to acquire (up to 32 ASCII code characters).
(Default: blank (public))
- Community Name (Read/Write):
You can enter the community name to acquire/write (up to 32 ASCII code
characters). (Default: blank (private))
- Trap Community Name:
You can enter the community name for trap notification (up to 32 ASCII code
characters). (Default: blank (SNMP_trap))
- System Administrator's Login ID:
You can enter information related to the person in charge of maintenance of the
machine (up to 127 ASCII code characters)(Default: blank).
Authentication Failure Generic Traps
You can check [Enabled] to send an authentication failure trap notification when an
access attempt was made with an invalid community name not registered in the
machine. (Default: On)
Advanced button
You can make the following settings by pressing this button:
z
Add UDP IPv4 Address button
You can add a recipient address for UDP IPv4 trap notification by pressing this
button.
- IP Address:
You can enter the IP address for entry.
- UDP Port Number:
You can set the UDP port No. for entry (a value between 1 and 65535).
- SNMP Version:
You can specify the SNMP version for entry as [v1] or [v2c]. (Default: v1)
- Trap Community Name:
You can enter the trap community name for entry (between 1 and 32 ASCII code
characters). (Default: SNMP_trap)
To Next Page
Loading...
