10 CentreWare Internet Services
164
Emulation Settings Left/Right Adjustment – Allows you to specify a value
between -250 and 250 mm to adjust the horizontal position
of a hard clip area.
Paper Margin – Allows you to specify a value between 0 and
99 mm for the paper margin.
Gradation Mode – Allows you to select the gradation mode.
Palette Setup – Allows you to select the palette priority
setup.
Kanji Font – Allows you to specify the kanji font.
Alphanumeric Font – Allows you to specify the alphanumeric
font.
Stapling – Allows you to select the stapling method.
HP-GL Mode – Allows you to select the HP-GL mode.
Eject Command – Allows you to select the eject commands.
Image Enhancement – Allows you to enable or disable
image enhancement.
Bypass Tray - Wait User – Allows you to specify whether to
enable/disable this feature when the Tray 5 (Bypass) is
selected.
Pen Properties – Allows you to specify pen properties.
Pen Number – Lists the pen numbers.
Pen Width – Allows you to specify the pen width.
Line End – Allows you to specify how a line ends.
Line Intersect – Allows you to specify the shape of two lines
intersecting each other.
Density – Allows you to specify grayscale ink density
between 0 to 100 points in 5 point increments.
PCL
This page allows you to configure the settings when PCL is
enabled.
Paper Tray – Allows you to select the paper tray.
Output Size – Allows you to select the paper size.
Paper Size (Bypass) – Allows you to select the paper size for
Tray 5 (Bypass).
Output Destination – Allows you to select the destination for
your output.
Quantity – Allows you to specify the number of sets to print
between 1 and 999.
2 Sided Print – Allows you to select whether to print both
sides of paper.
Image Orientation – Allows you to select the image orientation.
Form Lines – Allows you to specify the page length (printing
area) of one page.
Font – Allows you to select the required font from the list of
fonts available.
Font Size – Allows you to specify the font size between 4.00
and 50.00 points in 0.25 point increments.
Font Pitch – Allows you to specify the font pitch between
6.00 and 24.00 points in 0.01 point increments.
Symbol Set – Allows you to select the desired symbol set
from the list of symbol sets available.
Handle CR As – Allows you to enable or disable carriage
return and line feed for the PCL mode.
Feature Setting items
To Next Page
Loading...
