Fuji Xerox Document Centre 336 series User Manual

Network Settings
199
USB
Use this feature to specify whether to enable the USB port and to configure the relative
parameter settings.
Port Status
Specify whether to enable the USB port.
Print Mode
Specify the PDL to be used for print jobs. Only pre-installed PDLs are available.
PJL
Specify whether to enable the PJL.
Auto Eject Time
Specify the time-out period when print data is not sent to the machine sequentially. If
the specified time elapses, the remaining data inside the machine is automatically
printed out. You can enter a time within the range of 5–1,275 seconds in 5-second
increments.
Adobe Communication Protocol
Specify the communication protocol format for Adobe Communication Protocol.
• Standard – Select this option when the communication protocol is in the ASCII
format.
• Binary – Select this option when the communication protocol is in the binary format.
Depending on the data, the print job may be completed faster than [Standard].
• TBCP – Select this option to switch the specific control codes when the
communication protocols involve both ASCII and binary formats.
LPD
Use this feature to specify whether to enable the LPD port.
NetWare
Use this feature to specify whether to enable the NetWare port.
SMB
Use this feature to specify whether to enable the SMB port.
IPP
Use this feature to specify whether to enable the IPP port.
EtherTalk
Use this feature to specify whether to enable the EtherTalk port.
Salutation
Use this feature to specify whether to enable the Salutation port. This setting item is
available only when the hard disk is installed on the machine.

Fuji Xerox Document Centre 336 series Specifications

General

Brand	Fuji Xerox
Model	Document Centre 336 series
Category	All in One Printer
Language	English