SS1807-N002 Instruction of System － 50/106
2.5.4.3 Store common config data in external memory
When saving the configuration file, a “ep6000” folder is created in the external memory and the
configuration file “AdDatCom.dat” is saved in the “data” folder in the “ep6000” folder.
◆Note◆
・ Use an external memory for EP-6000.
If an external memory saved by another device other than EP-6000 is used, configuration data
may not be normally saved.
(1) Move the cursor to “Store common config data in Ext. Mem” using the [↑] and [↓] keys and
then press the [Enter] key.
(2) The message "Machinery common config data file will be saved in External Memory" is
displayed.
By moving the cursor to "Yes" and pressing the [Enter] key, the message "Saving
configuration file in External Memory" is displayed and saving the configuration starts.
◆Note◆
Do not touch the processor until the message "Saving configuration file is completed" appears.
If you turn off the power while saving config data, configuration file may not properly be saved.
(3) When the message "Saving configuration file is completed" appears, press the [Enter] key
to close the menu.
◆Note◆
If saving the configuration file has failed, the message at the right-hand side appears.
Confirm that the external memory is inserted correctly.
If this message appears again, replace the external memory.
To Next Page
