SS1807-N002 Instruction of System － 54/106
2.5.6 Light Source & Scope Logging
2.5.6.1 Export Light source log file
(1) Move the cursor to “Export Light source log file” using the [↑] and [↓] keys and then press the
[Enter] key.
(2) The message "Light source log file will be exported in External Memory" is displayed.
By moving the cursor to "Yes" and pressing the [Enter] key, the message "Exporting light
source log file in External Memory" is displayed and saving log files starts.
◆Note◆
・ Do not touch the processor until the message "Exporting light source log file is completed" is
displayed.
If the power is turned off during saving log files, the log files cannot be normally saved.
(3) When the message "Exporting light source log file is completed" is displayed, press the
Enter key to return to the backup screen.
◆Note◆
・ If saving fails, the following message appears.
Confirm if the external memory is correctly inserted and try again.
If the same message appears again, replace the external memory.
To Next Page
