INSTALLATION
2
2-9
2) The servo amplifier has the part that generates heat during operation.
To mount multiple servo amplifiers in the same panel, observe the following precautions.
- Mount side by side in principle. The RYB servo amplifier can be mounted closely. Use the
amplifiers at 80% ED rating* if they are installed in contact with each other. There is no
limitation in the operation frequency when amplifiers are mounted at 5 mm or larger intervals.
- Reserve 40 mm or a larger distance at the bottom of the servo amplifier.
- 50 mm or a larger distance is necessary above the servo amplifier for heat radiation.
* Servo amplifiers can be operated at 100% ED at ambient temperatures below 45°C.
i) Top: 50 mm or more
ii) Bottom: 40 mm or more
iii) Casing
About 10 mm
The value
assumes various
errors. The
distance can be
reduced to 0
mm.
iv) Interval between
amplifiers
About 5 mm
The value
assumes various
errors. The
distance can be
reduced to 0 mm.
To Next Page
