2
INSTALLATION
2-10
(4) Handling
The servo amplifier consists of electronic parts including microprocessors. Do not operate in the
following environment.
- Location near oil, steam or corrosive gas
- Location with much dust
Mount the servo amplifier in an airtight panel equipped with a forced ventilation fan when using it
at places with much dust.
Natural convection,
air tight structure
(enclosure)
Air purge
Forced duct
ventilation
Heat exchanger
Servo
amplifier
Servo
amplifier
Servo
amplifier
Servo
amplifier
Air
intake
Air
intake
Air
intake
Exhaust
air
Exhaust
air
- Location where strong electrostatic or magnetic field exists
- Accommodation in the same panel together with high voltage (3 kV, 6 kV) equipment
- Sharing of the same power supply with the equipment which generates large noise
- Under standing vibration
- In vacuum
- In explosive atmosphere
(5) Power supply to servo amplifier
Supply electric power to the servo amplifier in the specification range.
l Single-phase 100 V: 100 to 115 [VAC] (fluctuation: -15 to +10%)
l Three-phase 200 V: 200 to 230 [VAC] (fluctuation: -15 to +10%)
* Single-phase power supply can be used for three-phase 200V servo amplifiers with 400W
or smaller outputs.
To Next Page
