Preparing your notebook for use
Switching the notebook on for the first time
When you switch your notebook on for the first time, the supplied software is installed and
configured. Due to the fact that this installation procedure must not be interrupted, you
should set aside enough time for it to be fully completed and connect the notebook to the
mains outlet using the mains adapter.
!
During installation, the notebook may only be rebooted when you are requested to do so!
To make it easier to set your notebook up for the first time, the operating system is preinstalled on
the hard disk and the manuals are saved there.
► Switch the notebook on (see "Working with the notebook" chapter, "Switching the notebook on"
section).
► During installation, follow the instructions on screen.
Consult the operating system manual if anything is unclear about the requested input data.
i
If a Windows operating system is installed on your notebook, you will find additional
information on the system as well as the drivers, help programs, updates, manuals, etc. on
your notebook or on the "Drivers & Utilities" CD/DVD or on our website.
10600718714, edition 1 11
To Next Page
Loading...
Need help?
General
