Settings in BIOS Setup Utility
In BIOS Setup Utility you can set the system functions and the hardware configuration of the
notebook.
When it is delivered, the notebook is set to factory default settings. You can change these settings in
BIOS Setup Utility. Any changes you make take effect as soon as you save and quit the BIOS Setup
Utility.
The BIOS Setup Utility programme contains the following menus:
Information: For system information such as BIOS version, processor and notebook
identification
Main: For system settings such as time and date and information about the notebook
Advanced: For system settings such as interfaces and hard disks
Security: For security settings such as the password
Boot: For specifying the start order
Exit: For saving the changes and terminating the BIOS Setup Utility
Start BIOS Setup Utility
► Reboot the notebook (switch off/on or reboot operating system).
The following or a similar display appears on the screen during booting:
F2: Setup F12: Boot Menu
► When this message appears, press the function key F2 .
i
If a password has been assigned:
► Enter the password and press the Enter key.
If you have forgotten the password, contact your system administrator or contact our
customer service centre.
10600718714, edition 1 57
To Next Page
Loading...
Need help?
General
