Fujitsu CELSIUS H7510 - Removing the Touchpad Buttons Sub Board

Page 28 of 52
Only intended for authorised service technicians
Removing the touchpad buttons sub board
Required work steps:
■ Removing the battery
■ Removing the service door
■ Removing the 2.5” HDD
■ Removing the LTE module
■ Removing the WLAN module
■ Removing the lower assy
Required tools:
■ Screwdriver: Phillips PH00
► Remove both screws M2.5XL6 (yellow circles).
► Open all connector locks (green arrows) upwards and remove the flexprint cables.
► Remove the sub board (orange arrow).
Return to Table of Contents