Only intended for authorised service technicians
Required work steps:
■ Removing the battery
■ Removing the service door
■ Removing the memories under the service door
■ Removing the 2.5” HDD
■ Removing the LTE module
■ Removing the WLAN module
■ Removing the lower assy
■ Removing the M.2 module under the service door
■ Removing the fan
■ Removing the mains connection
Required tools:
■ Screwdriver: Phillips PH00
► Remove both screws M2.5XL6 (yellow arrows).
► Open the display cable connector lock (orange arrow) and disconnect the cable from the bracket
(blue arrows).
► Open the four connector locks (green arrows) upwards and remove the flexprint cables.
► Carefully tilt the mainboard away from you so that you can reach the sub board below the heatsink.
► Open the connector lock (green arrow) upwards and remove the flexprint cable.
► Remove the mainboard.
Return to Table of Contents
To Next Page
Loading...
