Fujitsu CELSIUS H7510 - Disposal Information for Recycling Companies

Page 51 of 52
For recycling companies
Disposal information for recycling companies
These instructions are for the complete dismantling of a Fujitsu product. All materials can thereby be disposed of according to their
provision in the EC directive 2012/19/EC (Waste Electrical and Electronic Equipment (WEEE)).
Product group: Mobile PC
Model: CELSIUS H7510
Designation Remarks Quantity
Printed circuit boards w ith a surface area greater
than 10 cm²
Mainboard
AC adapter
LCD
HDD or SSD
Memory
Touch Pad
1
1
1
1-3
1-4
1
Depending on system configuration:
WWAN
Port replicator
Mouse
1
1
1
Batteries Lithium-ion battery
- Method of attchment: Detachable
- How to remove: Unlock a latch
- Special tool for removal: None
1
Lithium button batteries CR2032
- Included on the mainboard
1
Components containing mercury Not contained
Liquid crystal displays (if applicable, together w ith the
casing) with a surface area greater than 100 square
centimetres and backlit displays w ith gas discharge
lamps
> 100cm2 display: Yes, for its display
Gas discharge lamps: No
1
Cathode ray tubes Not contained
Capacitors containing PCBs (PolyChlorinated
Biphenyls)
Not contained
Electrolytic capacitors which contain critical
substances (height > 25 mm; diameter: > 25 mm or
proportional similar volumes).
Not contained 0
External electrical cables AC adapter cable 1
Gas discharge lamps Not contained
Chlorofluorocarbons (CFC),
hydrochlorofluorocarbons (HCFC) or
hydrofluorocarbons (HFC), hydrocarbons (HC)
Not contained
Plastics w hich contain brominated flame retardant
This product may contain plastic parts w ith Brominated flame retardants but to the best of our knowledge w e provide this information to
sort them out. Plastic parts location can be visually identified by their typical design function for the product (also show n in the
disassembly manual).
Many of these parts (Greater than 25 grams) are bromine free.
Regardless, these parts are labeled (usually molded directly into the plastic) per ISO 11469.
A typical label w ould look like:
> Polymer Abbreviation - FR(xx) <
i.e. > PC+ABS FR(40) <
Flame retardant codes (FR(xx)) are given in ISO 1043-4. Codes for some Brominated flame retardants:
14 aliphatic/alicyclic Brominated compounds
15 aliphatic/alicyclic Brominated compounds in combination w ith antimony compounds
16 aromatic Brominated compounds (excluding Brominated diphenyl ether and biphenyls)
17 aromatic Brominated compounds (excluding Brominated diphenyl ether and biphenyls) in combination w ith antimony compounds
22 aliphatic/alicyclic chlorinated and Brominated compounds
42 Brominated organic phosphorus compounds
- Plastics parts w eighing less than 25 grams may or may not contain brominated flame retardants.These smaller plastics parts may to be
finding all over the PC system. It may especially include: fan, speaker.
Toner cartridges, liquid and paste-like, and colour
toner
Not contained
Asbestos w aste and components which contain
asbestos
Not contained
Components w hich contain fire-proof ceramic fibres Not contained
Components w hich contain radioactive substances Not contained
Does the product contain mass storage devices? If
so, is any of them soldered to a circuit board?
Mass storage devices are contained, and they are not soldered to a circuit board. 1 - 3
Materials which must be disposed of in a special manner
Mass storage device(s)
Required tools
Phillips screw driver