Fujitsu CELSIUS H7510 - Removing the Palm Vein;Fingerprint Sensor Sub Board

Page 29 of 52
Only intended for authorised service technicians
Removing the palm vein/fingerprint sensor sub board
Required work steps:
■ Removing the battery
■ Removing the service door
■ Removing the 2.5” HDD
■ Removing the LTE module
■ Removing the WLAN module
■ Removing the lower assy
Required tools:
■ Screwdriver: Phillips PH00
► Remove the screws M2.5XL6 (yellow circle).
► Remove the bracket in the direction indicated by the yellow arrow.