2. Installation and startup
To install the software on Linux operating systems, complete the following
steps:
1. Make sure you have the most recent version of the software by comparing
the version at http://www.ts.fujitsu.com/support/ to the version on the software
CD.
2. If a more recent version is available at www.fujitsu.com, download the newer
software and complete the following steps.
a. Open a command window and navigate the download directory, for
example:
% cd /home/username/temp
b. Enter the following command to start the install program:
% sh .setup.bin
3. If you are installing the software from the CD, insert the software CD into the
CD drive.
4. Issue the mount command manually. The following is an example of a typical
mount command:
mount -t iso9660
device_file mount_point
where device_file is the system-dependent device filename
and mount_point is the directory on which to mount the CD.
Typical default values include “/mnt/cdrom” and “/media/cdrom.”
See the Linux operating system documentation for the specific
mount command syntax touse.
5. Open a command window and navigate to the CD mount point. For example:
% cd /mnt/cdrom
6. Enter the following command to start the install program:
% sh ./KVMs4/linux/setup.bin
7. Follow the on-screen instructions.
2.3 Uninstalling the software
To uninstall the software on Microsoft Windows operating systems, starting
at the Control Panel, complete the following steps:
1. Open the Control Panel and select Add/Remove Programs. A sorted list of
currently installed programs opens.
590-1059-640A
10
To Next Page
Loading...
