3.7 Customizing properties
4. The Type field is read-only for switches. For a target device, select a type
from the pull-down menu or enter a 1 to 32 character type in the text field.
5. In the Icon field, select an icon from the pull-down menu.
6. In the Site, Department, and Location fields, select an entry from the pull-
down menu or enter a 1 to 32 character Site, Department, or Location in the
corresponding text field.
7. Complete one of the following steps:
• Click another tab to change additional properties.
• If finished, click OK to save the new settings.
• Click Cancel to exit without saving the new settings.
Network properties
For a switch, network properties include the address of the switch.
For a target device, network properties specify the URL to use when establishing
a browser connection to the target device. When this field contains a value, the
Browse button is visible in the Explorer task bar.
To view or change network properties:
1. Select a unit in the Unit list.
2. Complete one of the following steps:
• Select View-Properties from the Explorer menu.
• Click the Properties button.
• Right-click on the unit. Select Properties from the pop-up menu.
The Properties window opens.
3. Click the Network tab.
4. In the Address field (switches only), enter the switch address in IP dot
notation or 1 to 128 character host name. You may use either an IPv4 or an
IPv6 address. The address cannot be blank, a loopback address, all zeros or
a duplicate address.
5. In the Browser URL field (devices only), enter a 1 to 256 character URL for
establishing a browserconnection.
590-1059-640A
25
To Next Page
Loading...
