Fujitsu D943 - Page 23

Main - system functions Settings in BIOS Setup
A26361-D943-Z120-14-7619 15
Cylinders, Heads, Sectors/Track, Write Precomp - hard disk parameter
These hard disk parameters are set in accordance with the IDE hard disk drive. If
you want to change the hard disk parameters manually, set the
Type field to User.
Transfer Mode
This field specifies the transfer mode for the IDE hard disk drive.
Standard One block is transferred for each interrupt (default entry).
2 Sectors, 4 Sectors, 6 Sectors, 8 Sectors, 16 Sectors
The set number of blocks (sectors) is transferred for each interrupt.
LBA Translation - Addressing
This field enables and disables the LBA (Logical Block Addressing) mode. LBA
mode allows you to install and use IDE hard disks with a capacity of more than
528 Mbytes. If a hard disk supports LBA mode, you can use the full capacity of
the IDE hard disk.
The default entry depends on the installed IDE hard disk drive. Change the default
entries only if you are installing another hard disk drive.
!
You ma
y
onl
y
use IDE drives in the LBA mode selected when the
y
were
set u
p
. In other words, if
y
ou set u
p
a hard disk with LBA mode disabled,
y
ou ma
y
onl
y
o
p
erate the hard disk with LBA mode disabled.
Enabled If the hard disk supports LBA and it has a capacity of more than
528 Mbytes, the BIOS translates the hard disk parameters,
allowing the disk's full capacity to be used. This allows the disk's
full capacity to be used.
If the hard disk does not support LBA, its parameters are not
translated.
Disabled The BIOS uses the hard disk parameters and supports a maximum
capacity of 528 Mbytes.