Settings in BIOS Setup Power - power-management features
42 A26361-D943-Z120-14-7619
Hard Disk Timeout
Requirement: The Power Management Mode must be set to Customize.
This field defines the amount of time without system activity before the motor of
the hard disk drive is switched off. As soon as there is a hard disk access, the
motor is switched back on.
2 min, 5 min, 10 min, 15 min
Default entry = 10 min.
Disabled
The PC does not switch off the hard disk drive.
Standby CPU Speed
Requirement: The Power Management Mode must be set to Customize.
This field specifies the processor's clock speed in standby mode. The entries
High,
Medium and Low cause programs to run more slowly.
In a network environment the processor's clock speed must be set to
Max,
otherwise data transfer will take place at reduced speed.
Max Maximum clock speed
High 1/4 of maximum clock speed
Medium 1/8 of maximum clock speed (default entry )
Low 1/16 of maximum clock speed
Save To Disk
Requirement: The Power Management Mode must be set to Customize.Theremustbe
sufficient storage space on the hard disk.
This field specifies whether the current system status (active programs, files,
memory contents) is saved to file
SAVETO.DSK when the system switches to
suspend mode. This system status is restored when you restart the system; in other
words, you can carry on working in the same application.
Enabled The contents of the main memory, working memory, video
memory and cache are saved to the hard disk.
Disabled The memory contents are not saved (default entry).
To Next Page
Loading...
