Fujitsu D943 - Advanced System Configuration

Advanced - advanced system configuration Settings in BIOS Setup
A26361-D943-Z120-14-7619 29
PCI Device, Slot #n: Default Latency Timer
specifies the lowest number of clock cycles in which a PCI master board can be
active at the PCI bus;
n stands for the number of the PCI slot. For the change to
take effect, you must switch your PC off and then on again after the Setup BIOS
has terminated.
Yes The value predefined by the PCI board is accepted. The entry in
the corresponding field for PCI Device, Slot #n:
Latency Timer is
ignored
No The value predefined by the PCI board is ignored. The value set in
the relevant field of
PCI Device, Slot #n: Latency Timer determines
the number of clock cycles.
PCI Device, Slot #n: Latency Timer
Requirement: The relevant field of
PCI Device, Slot #n: Default Latency Timer must
be set to
No.
The field defines the lowest number of clock cycles in which a burst can be
transferred on the PCI bus.
n stands for the number of the PCI slot.
0000h to 0280h Number of clock cycles (default entry = 0040h).
Advanced System Configuration
calls the submenu in which you can make additional settings.
Phoenix BIOS Setup
A
dvanced
Advanced System Configuration Item Specific Help
ISA Memory Gap: [Disabled]
Parity Mode: [Disabled]
Memory Performance: [Fast]
Cache Performance: [Fast]
Memory Current: [8mA]
Feature Connector: [Disabled]
F1 Help ↑↓ Select Item -/+ Change Values F9 Setup Defaults
ESC Exit
← → Select Menu Enter Execute Command F7 Previous Values
Example for submenu Advanced System Configuration