Settings in BIOS Setup Advanced - advanced system configuration
30 A26361-D943-Z120-14-7619
ISA Memory Gap
inserts a contiguous ISA memory area of 1 Mbyte into the main memory area of 15
to 16 Mbytes.
Enabled The ISA memory area is inserted.
Disabled The ISA memory area is not inserted (default).
Parity Mode - DRAM Parity Check
Determines whether a parity check is carried out in the case of DRAM modules. If
the system BIOS detects that at least one DRAM module does not have a parity
bit, the parity check is generally disabled.
Disabled No parity check is performed.
Parity The parity check is set in parity mode. A bit corruption is recognized
and an error message is issued (default entry).
ECC A bit corruption is corrected (no error message).An error message is
issued for two or more bit corruptions.
Memory Performance
determines whether greater tolerances should be permitted for memory timing.
Standard Memory timing is programmed for EDO memory modules which
takes account of all possible tolerances.
Fast Setting performance of system.
Cache Performance
determines whether greater tolerances should be permitted for cache timing.
Standard Greater tolerances are permitted for cache timing.
Fast Setting performance of system.
Memory Current
defines the memory current to be supplied to the memory modules.
8mA The memory modules are supplied with 8mA memory current.
12mA The memory modules are supplied with 12mA memory current.
The 12mA setting is only necessary if you are using memory
modules with a large storage capacity (upwards of 64 Mbyte),
which have a large number of memory chips.
Feature Connector - Enabling of Feature Connectors
This field is used to enable and disable the feature connector on the system board.
Enabled The feature connector is enabled.
Disabled The feature connector is disabled (default entry).
To Next Page
Loading...
