Settings in BIOS Setup Power - power-management features
44 A26361-D943-Z120-14-7619
Wakeup Event - Defining system activities
This field calls the submenu in which you can set the interrupts which are to be
evaluated as system activities. When one of these interrupts occurs, the active
energy saving mode is terminated, for example.
In a network environment the
Wakeup Event for the network controller interrupt
must be disabled, otherwise the system will not switch to
Standby Mode.
Phoenix BIOS Setup
Power
Wakeup Event Item Specific Help
IRQ 1: Enabled
IRQ 3: [Disabled]
IRQ 4: [Disabled]
IRQ 5: [Disabled]
IRQ 6: [Enabled]
IRQ 7: [Disabled]
IRQ 8: [Disabled]
IRQ 9: [Disabled]
IRQ 10: [Disabled]
IRQ 11: [Disabled]
IRQ 12: [Enabled]
IRQ 13: Disabled
IRQ 14: [Enabled]
IRQ 15: [Enabled]
F1 Help ↑↓ Select Item -/+ Change Values F9 Setup Defaults
ESC Exit
← → Select Menu Enter Select Ê Sub-Menu F7 Previous Values
Example for Wakeup Event submenu
Enabled The associated interrupt is evaluated as a system activity.
Disabled The associated interrupt has no effect on the active energy saving
mode.
To Next Page
Loading...
