Settings in BIOS Setup Advanced - advanced system configuration
24 A26361-D943-Z120-14-7619
Serial 1 / Serial 2 - Serial interfaces
This field selects the address and the interrupt used to access the relevant serial
interface.
3F8h, IRQ4, 2F8h, IRQ3, 3E8h, IRQ4, 2E8h, IRQ3,
The serial port is set to the shown address and interrupt.
Auto The serial interface is automatically set to the next available
combination (address, interrupt) (Default entry).
Disabled The serial interface is disabled.
Serial 2 Mode - Serial interfaces
This field defines whether the second serial port is used as the standard port or as
the infrared interface.
If you wish to use infrared data transfer, an infrared interface with the associated
hardware must be incorporated in the device.
Standard The port operates as a serial port (default). Standard
IRDA (Infra-Red Data Association) The serial port permits infrared data
transfer up to 115 kbit/s. External serial port 2 does not function.
Parallel - parallel interface
This field selects the address and the interrupt used to access the parallel interface.
378h, IRQ7, 278h, IRQ5, 3BCh, IRQ7
The parallel port is set to the shown address and interrupt.
Auto The parallel interface is automatically set to the next available
combination (address, interrupt) (Default entry).
Disabled The parallel interface is disabled.
To Next Page
Loading...
